Chapter 1
14
UM10350_PCNC770_Manual_0916A
Preface
7.6.2.4 G83 Cycle 121
7.6.2.5 G85 Cycle – Boring Cycle (Feed rate out) 121
7.6.2.6 G88 Cycle – Boring Cycle (Dwell, Manual Out) 122
7.6.2.7 G89 Cycle – Boring Cycle (Dwell, Feed rate out) 122
7.6.2.8 Distance Mode – G90 and G91 123
7.6.2.9 Arc Distance Mode – G90.1, G91.1 123
7.6.2.10 Temporary Work Osets – G92, G92.1, G92.2 and G92.3 123
7.6.2.11 Feed Rate Mode – G93, G94 and G95 124
7.6.2.12 Spindle Control Mode – G96, G97 125
7.7 Built-in M-codes 125
7.7.1 Program Stop and Program End – M00, M01, M02 and M30 126
7.7.2 Spindle Control – M03, M04 and M05 127
7.7.3 Tool Change – M06 127
7.7.4 Coolant Control – M07, M08 and M09 127
7.7.5 Override Control – M48 and M49 128
7.7.6 Feed Override Control – M50 128
7.7.7 Spindle Speed Override Control – M51 128
7.7.8 Set Current Tool Number – M61 128
7.7.9 Set Output State – M64/M65 128
7.7.10 Wait on Input – M66 130
7.7.11 Operator Dened Commands – M100 to M199 130
7.8 Other Input Codes 131
7.8.1 Feed Rate – F 131
7.8.2 Spindle Speed – S 131
7.8.3 Change Tool Number – T 131
7.9 Advanced Programming with Parameters and Expressions 131
7.9.1 Parameters 131
To Next Page
Loading...
