Tormach PCNC 770 - Enclosures, Stands, and Machine Arms

Chapter 8
145
UM10350_PCNC770_Manual_0916A
Accessories
4th Axis Homing Kit
Tormach 4th Axis Kits do not have a built-in homing switch. An oponal homing kit is available that
ulizes an inducve-proximity sensor and plugs in to the mill’s accessory socket.
PN Description
31921 4th Axis Homing Kit
4th Axis Workholding Accessories
A large selecon of workholding accessories are available for Tormach 4th axis products including
tailstocks, 2-, 3-, and 4-jaw chucks, 5C collets/collet xtures, and Cast Iron Tombstone (PN 33146).
8.2 Enclosures, Stands, and Machine Arms
Full Enclosure Kits
A full enclosure kit is available for both PCNC mills. The PCNC 770 enclosure is shown in Figure 8.4.
Constructed from 16-gauge sheet metal, these feature large doors and overhead-task lighng.
A second enclosure opon, the DIY Frame Kit, is available for the PCNC 1100. It is designed as a
customized enclosure, and oers open access for overhead part loading (see Figure 8.5).
PN Description
34427 Full Enclosure Kit for PCNC 1100
34442 Full Enclosure Kit for PCNC 770
34655 DIY Frame Kit for PCNC 1100
Figure 8.4
Figure 8.5