Tormach PCNC 770 - Installation; Receiving, Uncrating, and Initial Inspection

Chapter 3
24
UM10350_PCNC770_Manual_0916A
Installation
3. Installation
This chapter covers basic installaon of a PCNC mill, which takes approximately
half a day. This esmate does not include oponal accessories like enclosures,
power drawbars, or automac tool changers (ATC).
Scan the QR code (at right) to view a list of related technical documentaon,
operator manuals, and support videos: hp://www.torma.ch/install
Recommended for Installaon
• Gloves • 4 mm Hex Wrench (included)
• Eye Protecon • Pallet Jack
• Pry Bar • Engine Hoist
• Strap Snips • Socket Set
• Screwdriver (included) • Liing Bar Kit
3.1 Receiving, Uncrating, and Initial Inspection
WARNING! Transport and Li Hazard: The transport, liing, and moving of mill should be done by
qualied professionals. Failure to do so may result in mill damage, serious injury or death.
3.1.1 Shipment Arrival
Depending on products and opons ordered,
the PCNC system arrives in one or more
shipments:
• PCNC mill (freight)
• Stand (freight)
• Accessory shipment (freight or parcel
service, depending on size)
IMPORTANT! Specic shipping informaon is
displayed on packing list. Wait unl all shipments
are received before beginning installaon.
3.1.2 Moving the Crate
The PCNC mill is loaded on a standard pallet
and can be o-loaded from a truck with a
tailgate li and moved (on smooth surfaces)
using a hydraulic pallet jack to the installaon
locaon (see Figure 3.1).
Figure 3.1