Tormach PCNC 770 - LED Spindle Light; Spindle Load Meter; Power Drawbar and ATC; Power Drawbar

Chapter 8
150
UM10350_PCNC770_Manual_0916A
Accessories
8.5.2.2 Spindle Load Meter
Operator-panel-mounted gauge measures
instantaneous spindle amperage and provides
the operator with a visual guide for determining
spindle load (see Figure 8.14); top mounts to
electrical cabinet of any PCNC mill.
PN Description
32096 PCNC 1100 Spindle Load Meter
31101 PCNC 770 Spindle Load Meter
8.5.2.3 LED Spindle Light
This is a bright LED work light that mounts to
the spindle nose of any PCNC mill.
PN Description
34846 LED Spindle Light Kit
8.6 Power Drawbar and ATC
8.6.1 Power Drawbar
A pneumac power drawbar system can be ed to any
PCNC mill (see Figure 8.15). The power drawbar system
can be used alone, or in conjuncon with a ATC.
PN Description
31706 PCNC 1100 Power Drawbar Kit
32436 PCNC 770 Power Drawbar Kit
The power drawbar system must be supplied with air
pressure between 90 psi and 120 psi. The air supply must
be dried and lubricated using a lter-regulator lubricator
(FRL). Only use oil that is specically designed for air
tools. The following components are recommended for
use with the power drawbar system:
PN Description
31945 Ultra Quiet Air Compressor
32457 FRL Filter-Regulator-Lubricator
31991 Pneumatic Hose Kit for PDB/ATC/Fogbuster
Figure 8.14
Figure 8.15