Tormach PCNC 770 - Table of Contents

Chapter 1
9
UM10350_PCNC770_Manual_0916A
Preface
3.3.5 Li and Move Mill 27
3.3.5.1 Remove Mill from Pallet 27
3.3.5.2 Liing Bar Kit 27
3.3.5.3 Liing from Below 27
3.3.5.4 Moving Kit (PCNC 770 Only) 28
3.3.5.5 Lowering Mill onto Stand 28
3.3.6 Install Tool Tray (PCNC 1100 only) 28
3.3.7 Install Drip Tray 28
3.3.8 Install PathPilot Controller 29
3.4 Installaon of Add-ons 31
3.4.1 Stand 31
3.4.2 Machine Arm 31
3.4.2.1 Mouse, Keyboard, and Jog Shule 31
3.4.3 USB Bulkhead Port 31
3.4.4 Manual or Automac Oiler 31
3.4.5 Coolant System 31
3.5 Essenal Controls Overview 32
3.5.1 E-stop, Start, Reset, and Power 32
3.6 Power O/Power On Procedure 33
3.6.1 Inial PathPilot Controller Conguraon 34
3.7 Validate Basic Installaon 34
3.7.1 Verify Spindle Funcon 34
3.7.2 Verify Limit Switch Funcon 35
3.7.3 Verify Axis Funcon 36
3.7.4 Coolant On/O 36
3.7.5 Installaon Troubleshoong 36
3.8 Controller Customizaon 37