Tormach PCNC 770 - Page 13

Chapter 1
13
UM10350_PCNC770_Manual_0916A
Preface
7.5.5 Set Osets – G10 105
7.5.5.1 Set Tool Table – G10 L1 105
7.5.5.2 Set Coordinate System – G10 L2 106
7.5.5.3 Set Tool Table – G10 L10 106
7.5.5.4 Set Tool Table – G10 L11 107
7.5.5.5 Set Coordinate System – G10 L20 107
7.5.6 Plane Selecon – G17, G18 and G19 108
7.5.7 Length Units – G20 and G21 108
7.5.8 Return to Pre-dened Posion – G28 and G28.1 108
7.5.9 Return to Pre-dened Posion – G30 and G30.1 109
7.5.10 Straight Probe – G38.x 109
7.5.10.1 Using the Straight Probe Command 110
7.5.11 Cuer Compensaon 111
7.5.12 Dynamic Cuer Compensaon – G41.1, G42.1 112
7.5.13 Apply Tool Length Oset – G43 112
7.5.14 Engrave Sequenal Serial Number – G47 113
7.5.15 G49 Cancel Tool Length Compensaon – G49 113
7.5.16 Absolute Coordinates – G53 114
7.5.17 Select Work Oset Coordinate System – G54 to G59.3 114
7.5.18 Set Exact Path Control Mode – G61 114
7.5.19 Set Blended Path Control Mode – G64 115
7.6 Canned Cycles 115
7.6.1 Preliminary Canned Cycle Moon 117
7.6.2 Canned Cycle – High Speed Peck Drill – G73 117
7.6.2.1 G80 Cycle 118
7.6.2.2 G81 Cycle 118
7.6.2.3 G82 Cycle 120