OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 2. /1
2. (305009) CROSS DRILLING ATTACHMENT 1600
COMPONENTS
Item Designation
030 Spindle
050 Notched pulley
090 Pin
150 Pin
1010 Spindle locking hole
CROSS DRILLING ATTACHMENT APPLICATION
The component of modular design is used on : DECO 2000 / ENC 75
Designation
305009 Cross drilling attachment
CROSS DRILLING ATTACHMENT DATA
Feature Description / Notes Data
Mounting positions : T21, T22, T23, T24
Capacity : ESX 12 7 mm
ET 12 M4
Circular cutter max. 20 mm
Height setting : 10 mm maxi
2, 3, 5, 10 mm acc. to
spacer thickness
Speed, max.: max. 12000 rpm
CROSS DRILLING ATTACHMENT OPERATION
The attachment is equipped with a spindle:
Spindle support: preloaded ball bearings in the front deep groove ball bearing
in the back. The bearings are pregreased for life.
Spindle drive: over a notched pulley,screwed and secured at the rear end of
the spindle
Spindle locking: over Hole 1010 to unscrew ESX nut
305009
Secured with C31
1010
TOOLHOLDER CHANGE
Identical with Gang Toolholder Change 305018: see Instruction 300231,
Page 8/19.
See also Gang Tooling Drive Belt Layout 305018: ditto, Page 8/17
To Next Page
Loading...
