OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 5.2 /3
5.2 (305143) FIXED SPINDLE FOR WJ8 COLLETS (WATCH INDUSTRY) 3115
COMPONENTS
Item Designation
020 Eccentric sleeve
030 Spindle
230 Spindle locking screw
240 Axial setting screw
260 Lateral setting screw
TECHNICAL DATA FOR WJ8 FIXED SPINDLE (WATCH INDUSTRY)
Feature Description Data
Mounting stations : T31, T32, T33
Capacity : WJ8 4 mm
M4
Part length : maxi 30 mm
Longitudinal setting : (Z3) 40 mm
Lateral setting : (Y3) +/− 0,5 mm
Off-center radius : 3 mm
CHANGING TOOLHOLDER
To start with : Put the machine in SETTING mode.
What to do ? Notes
Dismounting
Unscrew both Fastening screws
120.
Dismount the toolholder.
Mounting
Fit the toolholder in place ...
Fit + tighten both Fastening screws
120.
... locating it with two pins.
LATERAL SETTING OF TOOLHOLDER
To start with : Put the machine in SETTING mode.
What to do ? Notes
Setting
Loosen both screws 260.
Unscrew one of them and screw in
the other one and proceed to set ...
Tighten both screws 260 ...
... by pivoting Eccentric sleeve 020.
... once set as required.
To Next Page
Loading...
