OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 6.1 /3
6.1 (305056) SLOTTING ATTACHMENT FOR BACK-
WORKING
4700
COMPONENTS
Item Designation
140 Removable steady
1020 Hexagonal hole (for locking the spindle)
SLOTTING ATTACHMENT DATA
Feature Description / Notes Data
Cutter ∅: ∅ < or = 50 mm
Capacity: ESX 12 7 mm
Speed: 0−9000 rpm
SLOTTING ATTACHMENT OPERATION
Application of removable steady: for vibration-free machining with slitting saw
on arbor
Drive: over a pair of bevel gears and timing belt
CHANGING SLOTTING TOOLHOLDER
To start with: Put the machine in SETTING mode.
What to do ? Notes
Dismounting
Take down Steady 140 ...
Remove the collet nut ...
... by undoing two Screws 310.
... while locking the spindle in Hole
1020.
Mounting
Change the tool.
Screw on the collet nut ...
Mount Steady 140.
... while locking the spindle in Hole
1020.
GREASING BEVEL GEARS
Maintenance Interval: Grease bevel gears annually
or every 3000 hours’ operation.
What to do ? Notes
Dismounting
Undo and remove four Screws 360.
Pull out the drive shaft unit.
Do not lose Rings 170.
Greasing
Proceed to grease the pair of bevel
gears.
See Instruction 300231, Para 2.2.2:
MANUAL GREASING OF PINION
OR BEVEL GEARS
Mounting
Fit in the drive shaft unit.
Screw in and tighten four Screws
360.
To Next Page
Loading...
