OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 8.3.1 /7
. Caution !
− Mist & Smoke Control Unit capacity may prove inadequate if your
working environment produces too much mist & smoke.
− Follow strictly the FILTERMIST supplier’s instructions.
EXAMPLE OF MISAPPLICATION
No Stock Operation Coolant Solution retenue
1 Stainless
steel
Turning
Deep drilling
Oil / 120 bars Emulsion !!
. Caution !
1. The filter must work uninterrupted when the lathe operates:
2. When connecting the filter, make sure the motor rotation direction is
correct.
3. Inspect annually the housing, drum & antivibration supports.
4. If the machine is mounted on an antivibration support, make sure
that the two retention belts are mounted according to
the instructions.
5. Let the drum stop before you remove the cover clips.
PREMOUNTING FILTERMIST UNIT
Départ usine
FILTERMIST UNIT MAINTENANCE
Maintenance interval : Carry out the maintenance works annually
or every 3000 hours’ operation.
To start with : Read the LESTOPREX’s operation &
service instructions.
Δ Warning ! Turn Main Switch off & lock it.
What to do ? Notes
− Replace the anti-vibration sup-
ports & torque limitation belts.
− Replace the foam silencer on the
output side.
− Take down & clean the drum thor-
oughly inside.
Be careful not to damage it.
− Replace the foam filter cartridges.
− Replace the filter for dry smoke.
To Next Page
Loading...
