OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 14.4 /5
14.4 NSK SPINDLE
Operation and maintenance: see the NSK NAKANISHI INC. supplier’s docu-
mentation, delivered with each attachment.
Pneumatic drive: acc. to Diagram 305098 in Page 10/6 and Electrical Docu-
mentation 222 E 02 01
Lubrication rate to set: 30 to 40 drops per minute
The motor must not run without oil.
. Caution !
Wait about 2 min before the oil reaches the spindle.
Checking: Disconnect at spindle level and wait till oil arrives.
Oil: acc. to the table below
ENERGOL
HLP−D10
TELLUS
OIL C 10
VELOCITE
OIL No. 6
DTE 21
Mobil
M
OTOREX
Pneumatics
Standard
COREX
EP D10
ISO 10
ISO−L−FD 10
>>>
To Next Page
Loading...
