IT2200 Reader System with Multimode Capability Installation & Maintenance/Service Guide
6-20
Data Cable
Removal
To remove the data cable
1. Turn off power to the RF module and computer housing the reader logic card.
2. Disconnect the data cable.
Replacement
To install the replacement data cable
1. Connect the loopback connector to the new cable and test the cable for continuity.
2. Connect the new cable to the RF module and reader logic card.
3. Turn on power to the RF module.
4. Check the lane tuning as described in “Testing the Footprint” on page 5-11.
Antenna Cable
Removal
To remove an antenna cable
1. Turn off power to the RF module.
2. Disconnect the antenna cable.
Replacement
To install a replacement antenna cable
1. Connect the new cable to the RF module.
2. Place a piece of heat shrink tubing over the antenna cable.
3. Connect the cable to the antenna.
4. Turn on power to the RF module.
5. Check the lane tuning as described in “Testing the Footprint” on page 5-11.
6. When lane tuning is complete, heat the shrink tubing covering the antenna cable
connectors.
To Next Page
Loading...
