UTT Technologies VPN Menu
http://www.uttglobal.com Page 163
Enable NAT: If selected, it will only allow unidirectional access from the PPTP
client-side LAN to the server-side LAN.
Tunnel Name: Specify a unique name for the PPTP tunnel.
User Name: Specify the username of the PPTP client.
Password: Specify the password of the PPTP client.
PPP Authentication: Specify the PPP authentication mode of the PPTP tunnel.
The available options are
PAP, CHAP , MS-CHAPV2 and ANY.
PAP: Password Authentication Protocol.
CHAP: Challenge Handshake Authentication Protocol.
MS-CHAPV2: the Microsoft version of the Challenge-Handshake
Authentication Protocol.
ANY: If selected, the Device will automatically negotiate it with the remote
VPN appliance.
Encryption: Select the way of data encryption mode. Note when you choose
MS-CHAPV2 as PPP authentication mode, you must select MPPE as data
encryption mode.
Remote Subnet IP Address: Specify the IP address of the remote network.
Remote Subnet Mask: Specify the subnet mask of the remote network.
Server IP/Domain Name: The public IP address or domain name of the remote
PPTP server.
MTU: Specify the largest packet size permitted for network receive. During
dialing, The Device will automatically negotiate it with the remote VPN appliance
when dialing. Unless special application, please leave the default value of 1478
bytes.
13.2.4 PPTP List
After you have configured a PPTP client or server entry, you can view its configuration
and status information in the
PPTP List.
To Next Page
Loading...
