UTT Technologies Advanced Menu
http://www.uttglobal.com Page 80
Dest Port: Specify the start and end port numbers in the associated text boxes.
The port number is between 1 and 65535.
Schedule Settings: Specify a schedule to restrict when the Policy Routing entry
takes effect. The default value is
Every Day and All Day, which means the Policy
Routing entry will be in effect always.
Note:
Policy Routing takes precedence over the Device’s normal destination-based routing.
That is, if a packet matches all the criteria (source address, destination address,
protocol type, port, etc.) specified in a Policy Routing entry, it will be forwarded
through the outbound interface specified in the Policy Routing entry. If no match is
found in the Policy Routing list, the packet will be forwarded through normal routing
channel (in other words, destination-based routing is performed).
7.4 Anti-NetSniper
This section describes Advanced > Anti-NetSniper page.
Anti-NetSniper is used to crack shared Internet access detection which can be
performed by your ISP. Don't enable this feature unless you encounter the "shared
Internet access detection" issue.
Figure 7-17 Anti-NetSniper
7.5 Plug and Play
Plug and Play is a new feature of UTT series security firewalls. If you enable plug and
play feature on the Device, the LAN users can access the Internet through the Device
without changing any network parameters, no matter what IP address, subnet mask,
default gateway and DNS server they might have. Obviously, this feature can greatly
facilitate the users. As this feature is suitable for hotel network, we also call it hotel
special version.
To Next Page
Loading...
