UTT Technologies Wireless Menu
http://www.uttglobal.com Page 43
Chapter 5. Wireless Menu
This chapter describes how to configure and use the 2.4GHz wireless features of the
Device. You can access to the 2.4GHz wireless application by clicking
Wireless menu.
5.1 Basic
In the Wireless > Basic page, you can configure the AP operation mode, SSID,
wireless mode, wireless mode, channel, channel bandwidth, enabling or disabling the
SSID broadcast and other functions of the Device.
WDS (Wireless Distribution System) is a protocol for two access points (AP) in
wireless connection. Throughout the WDS wireless network, multiple APs are
connected by the way of bridging or repeater, make the entire LAN be dominated by
wireless mode.
The WDS configuration provided by the Device consists of three modes: Bridge Mode,
Repeater Mode and Lazy Mode, which only plays a bridging function in the practical
application. Note: In the configuration, the LAN IP of the device must be in the same
network segment while the parameters for security mode and channel bandwidth for
connecting with each other must be consistent.
The parameters of the Basic page will be introduced in the order of four kinds of
working mode, AP mode, Repeater mode, Bridge mode, Lazy mode.
To Next Page
Loading...
