UTT Technologies Appendix A FAQ
http://www.uttglobal.com Page 198
Appendix A FAQ
Question 1: How to configure TCP/IP?
There are two methods of configuring TCP/IP properties: one is to manually configure
TCP/IP properties; the other is automatically configuring TCP/IP properties with DHCP.
The following describes the configuration procedure of these two methods respectively.
Method I: Manually Configuring TCP/IP
To configure the TCP/IP protocol manually, do the following:
Step 1 On the Windows taskbar, click Start > Control Panel > Network and
Connection > Local Area Connection, right-click Local Area Connection, and
choose
Properties.
Step 2 In the Properties dialogue, double-click Internet Protocol Version 4
(TCP/IPv4).
Step 3 In the Internet Protocol Version 4 (TCP/IPv4) dialogue, select the Use the
following IP address radio button, Enter 192.168.1.x (x is between 2 and 254,
including 2 and 254) in the
IP Address box, enter 255.255.255.0 in the
Subnet Mask box, and Enter the IP address of the Device’s LAN interface
(default value is 192.168.1.1) in the
Default gateway text box.
Step 4 Select the Use the following DNS server addresses radio button, Enter the IP
address of DNS server into the
Preferred DNS server text box.
To Next Page
Loading...
