UTT Technologies Wireless Menu
http://www.uttglobal.com Page 53
Add: Click to enter into MAC Address Filtering Settings page to configure the
MAC addresses to be filtered.
Figure 5-9 Configuration of MAC address filtering
5.4 Advanced
On the Wireless > Advanced page, you can setup advanced parameters of the
wireless mode, such as RTS Threshold, Fragmentation Threshold, and so on. In most
case, you can keep it as the default value but you have special needs.
Figure 5-10 Advanced Wireless Settings
RTS Threshold: Specify the value of RTS Threshold. Value range is 1~2347 bytes,
and the default is 2347 bytes. Typically, sending RTS/CTS frames does not occur
unless the packet size exceeds this threshold. If the packet size that the node
wants to transmit is larger than the threshold, the RTS/CTS handshake gets
triggered. The process of transmitting data is as following:
1) Device A (for example) initiates the process by sending a Request to Sent
(RTS) to Device B (for example).
2) Device B replies with a Clear To Send (CTS).
3) After receiving CTS, Device A sends data.
RTS/CTS is the optional mechanism used by the 802.11 wireless networking
To Next Page
Loading...
