UTT AC750W - Page 175

UTT Technologies VPN Menu
http://www.uttglobal.com Page 168
(1) Creating the PPTP Dial-up Connection
a) Go to Start > Settings > Control Panel, and select the Switch to Category View.
b) Select Network and Internet Connections.
c) Select Create a connection to the network at my workplace.
d) Select the Virtual Private Network connection option, and then click the Next
button.
e) Enter a name for the connection (PPTP in this example) in the Company Name
text box, and then click the Next button.
f) Select the Do not dial the initial connection option, and then click the Next button.
g) Enter the remote PPTP server’s IP address (200.200.202.123 in this example) in
the
Hostname or IP address text box, and then click the Next button.
h) Click the Finish button.
i) Double click the new connection PPTP and click the Properties button.
j) Select the Security tab, select the Advanced (custom settings) option and click
the
Settings button.
k) Select Optional Encryption (connect even if no encryption) from the Data
encryption drop-down list.
l) Select the Unencrypted password (PAP), Challenge Handshake Authentication
Protocol (CHAP), and Microsoft CHAP (MS-CHAP) check boxes in the Allow
these protocols and then click the OK button.
m) Select the Networking tab, select PPTP VPN from the Type of VPN drop-down
list.
n) Make sure that the Internet Protocol (TCP/IP) check box is checked.
o) Make sure that the NWLink IPX/SPX/NetBIOS Compatible Transport Protocol,
File and Printer Sharing for Microsoft Networks, and Client for Microsoft Networks
check boxes are cleared.
p) Click the OK button to save the changes to make them take effect.
(2) Connect the Computer to the Device through the PPTP Tunnel
a) Please make sure that your computer has been connected to the Internet.
b) Double-click the new connection PPTP you have just created.
c) Enter PC1 in the Username text box and PC1 in the Password text box.
d) Click the Connect button.
e) After the PPTP tunnel has been established successfully, if you run the ipconfig
command at the MS-DOS command prompt on the computer, you can see the IP
address assigned by the Device.