UTT Technologies Network Menu
http://www.uttglobal.com Page 20
Figure 4-2 PPPoE Connection Setup
ISP Policy: Select the ISP Policy (i.e., route policy database) for each Internet
connection. Thus all traffic destined to an ISP’s servers will be forwarded through
that ISP’s connection.
User Name and Password: Enter the PPPoE login username and password
provided by your ISP.
PPP Authentication: Specify the PPP authentication mode, available options:
NONE, PAP, CHAP and Either.
None: If selected, no protocol will be used.
PAP: If selected, PAP (Password Authentication Protocol) protocol will be
used for PPP authentication.
CHAP: If selected, CHAP (Challenge Handshake Authentication Protocol)
protocol will be used for PPP authentication.
Either: If selected, the Device will automatically negotiate with the peer
device to use PAP or CHAP protocol.
Dial Type: Select the type of dial connection, available options are Always On, On
Demand and Manual.
Always On: If selected, the Device will establish a PPPoE session when
starting up and automatically re-establish the PPPoE session once
disconnected.
To Next Page
Loading...
