Configuring Verification Settings
Note: The following settings apply to all verification zones (see Configuring Verification Zones on the
previous page).
1. Select Configuration > Advanced > Verification > Audio.
The following page is displayed.
2. Configure the following settings.
Pre-event
recording
Enter a required duration of pre-event audio recording, in seconds (0–
120). Default is 10.
Post-event
recording
Enter a required duration of post-event audio recording, in seconds (0–
120). Default is 30.
Viewing Video Images
Video images from the configured cameras can be viewed in the web browser in Full or Soft Engineer
modes. This functionality is also available to users that have the View Video right in their profile. (See
Adding/Editing a User on page196.) The Web Access right must also be enabled for this functionality.
The View Video right can also be set on the keypad (‘Video in Browser’ setting).
To view images, go to SPC Home > Video. See Viewing Video on page178.
See also
Adding/Editing a User on page196
Configuring Video on page291
17.10.7.5 Updating SPC Licenses
The License Options feature provides a mechanism for the user to update or add functionality to the
SPC system, for example, for migrations, where installed peripherals, which are not licensed for SPC,
need to be supported by an SPC controller.
1. Select Configuration > Advanced > License.
2. Contact technical support with the requested functionality and quote current license key as
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 294 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
