Wacker Neuson WL34 - Page 141

SHB WL34 * 2.0 2-7
Engine 2
Perkins engine 404D-22 (35.7 kW)
9. Remove connector 5.
10.Remove all associated cable ties on the engine.
11.Remove the fuel line 6. To do this, close the line with a pair of hose
pinch-off pliers.
12.Open the one-ear clamp and pull off the fuel line.
13.Remove the clip 7 and place the brake fluid reservoir to the side.
14.Remove fuel lines 8 and 9. To do this, close the lines with a pair of
hose pinch-off pliers.
15.Open the one-ear clamps and pull off the fuel lines.
16.Disassemble the bracket 10 with fuel filter.
17.Remove the clamps 11 and remove the wiring harness.
18.Remove all cable harness and ground fittings from the engine.
19.Remove the fuel lines to the fuel pump 12 and remove the pump.
20.Slightly loosen the screws on both sides of the underside of the
cooler 13.
21.Push the cooler as far back as possible.
Fig. 88
5
6
Fig. 89
7
Fig. 90
8
9
10
Fig. 91
12
11
Fig. 92
13