Wacker Neuson WL34 - Page 197

SHB WL34 * 2.0 5-7
Axles 5
Rear axle
10.Unscrew screws on sensors 3 and 5 and pull off sensors.
11.Loosen union nut 4 on the hydraulic hose.
12.Remove the hydraulic line.
13.Close the hydraulic hose and opening with plugs.
14.Remove screws 6 on the variable displacement motor and the
corresponding screws on the other side of the flange halves and
remove flange halves.
15.Remove the hydraulic hose.
16.Remove screws 7 and the corresponding screws on the other side of
the flange halves and remove flange halves.
17.Remove the hydraulic hose.
18.Close the hydraulic lines and variable displacement motor with plugs.
19.Loosen union nut 8 of the hydraulic line at the rear of the variable
displacement motor.
20.Remove the hydraulic line.
21.Close the hydraulic line and variable displacement motor with plugs.
22.Support rear axle with suitable support structure (for example, pallet
and pallet truck).
Fig. 149
3
4
5
4
Fig. 150
6
7
Fig. 151
8
Fig. 152