1-12 SHB WL34 * 2.0
1 Maintenance
Maintenance overview
Check the tire condition and tire pressure • • • •
Change the engine oil and engine oil filter (every 500 operating
hours)
•
Replace the fuel filter – clean the pre-filter • •
Clean the fuel feed pump (Deutz engines) • •
Clean the air filter, replace it if necessary • • • •
Replace the hydraulic oil • •
Replace the breather filter of the hydraulic oil reservoir •
Replace the hydraulic oil return filter • •
Pressure filter (initial replacement after 500 operating hours, further
replacement as required*)
Replace the oil in the transfer gearbox • •
Replace the oil in the axles • •
Replace the coolant – every 2 years
All grease zerks lubricated? Lubricate if necessary • • • •
Lubricate the cardan shafts (universal joint and sliding joint) • • • •
Lubricate with oil: all levers, Bowden cables and hinges • • • •
Check all oil/fluid levels • •
Clean the cabin breather filter, replace it if necessary •
Check according to the Ordinance on Industrial Safety and Health • •
Replace the diesel particulate filter every 3000 operating hours
* Required if there is damage in the hydraulic system that is supposed to be caused by strong abrasive wear
Valve clearance Perkins Series 400: inlet and exhaust 0.2 mm on a cold engine
Valve clearance Deutz Series 2011: inlet 0.3 mm and exhaust 0.5 mm on a cold engine
Work to be performed
Operating hours:
250, 750, 1000,
1250, 1750, 2000,
2250, 2750, 3000,
etc.
Operating
hours: 1500,
2500, 3500,
4500, etc.
Once a month
Once a year
To Next Page
