2 Install the e2695 Separations Module
46 July 29, 2013, 715003794 Rev. B
Major steps to installing the separations module:
Required materials:
• Screwdriver, #2 Phillips
®
• Screwdriver, flat-blade
• Open-end wrench, 5/16-inch
• Tubing cutter
• e2695 Separations Module Startup Kit
Once you install the separations module, proceed to Chapter 3.
Site requirements
The installation site must meet the specifications in the following table.
Installation
complete
Review site
requirements
Unpack and
inspect parts
Connect power
cables
Connect signal
cables
Connect tubing
Install hardware
options
Obtain required
materials
To Next Page
Loading...
