July 29, 2013, 715003794 Rev. B 135
5 Automatic Runs
You can set up the separations module to make automatic runs when it
operates as follows:
• In System Controller or No Interaction mode
• Controlled by Empower software
• Controlled by MassLynx software
See “Operating configurations” on page 34 for details about separations
module control modes.
System Controller or No Interaction mode
If your HPLC system uses the separations module in a System Controller or
No Interaction mode, you perform an automatic run using a sample set or
sample template stored in the separations module. Chapter 6 explains how to
create and store separation methods, sample sets, and sample templates. You
run existing sample sets and sample templates from the separations module’s
Main screen.
Contents:
Topic Page
Perform automatic runs in a standalone mode .............................. 136
Perform automatic runs under Empower software control ........... 142
Perform automatic runs under MassLynx control ......................... 144
To Next Page
Loading...
