Add hardware options
July 29, 2013, 715003794 Rev. B 81
Reinstall the right-hand side panel
This procedure applies only to a separations module with no column heater or
column heater/cooler option. If the column heater or column heater/cooler
option is installed, see page 202 for instructions on how to reinstall the side
panel on the separations module.
To reinstall the panel:
1. Mount the side panel on the rear panel posts.
2. Slide the side panel forward, aligning the red outlet tube with the slot in
the side panel.
3. Install the screws on the side panel.
4. Reconnect AC power to the separations module, and then power-on the
separations module.
Install the column heater and column heater/cooler
The column heater or column heater/cooler mounts onto the right-hand side
panel with three screws. A connector on the rear panel of the separations
module provides power and signal connections to the column heater or column
heater/cooler. See the Waters Alliance Series Column Heater and Column
Heater/Cooler Operator’s Guide for procedures explaining the installation,
operation, maintenance, and basic troubleshooting of the Waters Alliance
®
series column heater and column heater/cooler instruments.
Install a syringe
See “Replace the syringe” on page 205 for the procedure to install a syringe.
To Next Page
Loading...
