Waters Alliance e2695 - Perform Direct Functions

Perform direct functions
July 29, 2013, 715003794 Rev. B 123
Perform direct functions
The following figure outlines the procedure for using the front panel to set up
the separations module to perform a direct function.
Injector Indicates the current position of the needle port. Valid
positions are:
• Stream – In the high-pressure stream
• Seal – In the lower seal position
• Wet – In the needle wash position
• Vial – In the sample vial
486 (1) and (2)
• λ
•Lamp
•AUFS
Indicates the current status of the following parameters
for the 486 Detector(s) (if installed):
•Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
2487 (1) and (2)
• λ
•Lamp
•AUFS
Indicates the current status of the following parameters
for the 2487 Detector(s) (if installed):
•Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
2410 and 410
•Cell
•Col 1
•Col 2
Indicates the current status of the following parameters
for the 2414, 2410, or 410 Detector (if installed):
• Cell Temperature (detector oven temperature)
• External Temp 1
1
• External Temp 2
1
1. Enabled if the optional column heater or column heater/cooler module is configured with the
Waters 2414, 2410, or 410 Differential Refractometer.
Status screen parameters: (Continued)
Parameter Description