6 Create Methods, Sample Sets, and Sample Templates
162 July 29, 2013, 715003794 Rev. B
Set I/O parameter values
You set the I/O parameter values when you want to use analog signals to
notify other instruments of the status of the separations module. You can do
any of these things:
• Notify a detector that an injection began.
• Turn on a heating plate or a stirring bar in a solvent reservoir.
• Notify a third-party data system or integrator that an event occurred.
• Activate a switching valve.
• Sound a buzzer.
Column
Temperature
Range
Sets the maximum allowable
variation in column temperature. If
the temperature variation exceeds
the range, the alarm condition
selected in the adjacent box is
triggered.
±10 °C in 1 °C
increments
Column
Selection
3-Column
Valve
Selects a column position if a
column selection valve is installed.
Tip: Select No Change when you
link methods in a sample set and
do not want to change the column
from the previous method.
Position 1 through
Position 3, or No
Change
Column
Information
Displays the column information
you enter using the Column Info
screen key.
N/A
Column Info
(screen key)
Allows you to enter or modify the
column information field.
30 characters
Equilibration Allows you to specify an
equilibration time that will be
applied whenever the application
of the separation method involves a
change in the column switch
position.
<
999.99 minutes
Column parameters: (Continued)
Parameter Function Value range
To Next Page
Loading...
