212 EN MEDUCORE Standard
2
WM 68401 04/2021
6 Operation
6.19 Uploading data to an external device
via Bluetooth
®
interface (only with
Bluetooth
®
data transmission option)
Requirement • The Bluetooth
®
data transmission option is enabled and
activated (see “13.12 System settings”, page 342).
• An external device with a Bluetooth
®
interface (Example:
System for digital patient data recording) is within range.
• The user menu is activated (see “10.1 Navigating the user
menu”, page 252).
1. Select the Bluetooth
®
data transmission menu item.
When doing so, please note:
•The Bluetooth
®
data transmission menu item is grayed
out as long as the printer is printing.
• During Bluetooth
®
data transmission, the device cannot
connect to a printer.
2. Start Bluetooth
®
data transmission on the external device.
3. If the device and the external device are not yet paired: Check
whether the PIN displayed on the device is shown on the
external device.
4. If the PIN displayed on the device and on the external device are
identical: Confirm the pairing on the device and the external
device.
Device and external device are paired.
5. If the device is ready for Bluetooth
®
data transmission: Await
completion of Bluetooth
®
data transmission.
6. Finish Bluetooth
®
data transmission using the Finish function
button.
Result Bluetooth
®
data transmission between the device and the external
device has been set up. Device data have been uploaded to the
external device.