WM 68401 04/2021
MEDUCORE Standard
2
EN 227
7 Disassembling
3. Open the safety closure.
4. Disconnect the NIBP cuff from the NIBP connecting tube.
5. If necessary: Pass all tubes through the respective openings in
the protective transport bag.
Result An NIBP cuff and the NIBP connecting tube have been
disassembled.
7.6 Disassembling the device from the
protective transport bag and the
retaining plate
Required auxiliary
equipment
Phillips screwdriver, size PH1
1. Place the protective transport bag with its back on a level, firm
surface.
2. Release the magnetic catch of the protective transport bag and
open the viewing window.
3. Disconnect all cables and tubes from the device.
4. Open the snap fasteners between the retaining plate and the
protective transport bag.
To Next Page
Loading...
