74 EN MEDUCORE Standard
2
WM 68401 04/2021
4 Preparation
4 Preparation
4.1 Mounting the device
4.1.1 Mounting the device in the protective
transport bag
Required auxiliary
equipment
Phillips screwdriver, size PH1
1. Place the device on a smooth, firm surface with the control
panel membrane facing down.
2. Put the retaining plate on the device.
When doing so, please note: The holes of device and retaining
plate must line up.
3. Screw the device to the retaining plate using screws.
4. Place the protective transport bag with its back on a level, firm
surface.
5. If the protective transport bag is closed: Release the magnetic
catch of the protective transport bag and open the viewing
window.
To Next Page
Loading...
