EasyManua.ls Logo

Weinmann MEDUCORE Standard2 - Using the Battery

Weinmann MEDUCORE Standard2
396 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
86 EN MEDUCORE Standard
2
WM 68401 04/2021
4 Preparation
4.4 Using the battery
4.4.1 General instructions
Always operate the device with a battery.
Note the methods of storing the battery and the charging
intervals for extended storage (see “15.2 Storing the battery”,
page 355).
The intended lifetime of the battery is 2 years.
Recommendation: Replace the battery after 2 years. If battery
operating time has substantially dropped before then, replace
the battery earlier.
If you receive a replacement battery, you need to charge it fully
before the first use.
4.4.2 Charging the battery in the device
Requirement The portable unit is suspended in a wall mounting with a
charging interface.
Alternatively:
The device is connected to line power with the charging
adapter and power supply unit and charger.
Alternatively:
The device is connected to a 12 V on-board power supply with
the charging adapter and the adapter cable for 12 V on-board
power supply/circular connector.
1. Insert battery into the battery compartment.
When doing so, please note:
Charging starts automatically if the following conditions
are met:
Specification Description
External voltage 12 V to 15.1 V
Battery status < 95 % charged
Battery temperature Between 0 °C and 45 °C

Table of Contents

Related product manuals