290 EN MEDUCORE Standard
2
WM 68401 04/2021
12 Configuration by the operator
12 Configuration by the operator
12.1 Enabling options
Requirement There is an enable code for a new option.
1. Activate the operator menu (see “13.1 Activating the operator
menu”, page 307).
2. Select System settings | Enable options | Enter enable
code.
3. Enter the enable code for the new option.
The new option appears as a selection under System
settings | Enable options.
4. Activate/deactivate a new option with a check mark.
Result A new option is enabled for use and activated/deactivated.
12.2 Pair printer with device (only with
Printing option)
Requirement • A charged printer battery is inserted (see “4.7.2 Inserting the
printer battery”, page 97).
• The printer paper is inserted (see “4.7.3 Inserting printer
paper”, page 98).
• The Printing option is enabled and activated (see “13.12
System settings”, page 342).
1. Position the printer next to the device.
2. Press the On/Off button of the printer for > 5 s.
The status indicator of the printer is green and an audible signal
sounds.
3. Switch on the device (see “6.1 Switching on the device”,
page 118).
The start menu appears.
4. Activate the operator menu (see “13.1 Activating the operator
menu”, page 307).
To Next Page
Loading...
Need help?
General
