WM 68401 04/2021
MEDUCORE Standard
2
EN 89
4 Preparation
4.5 Using the charging station
4.5.1 Mounting the charging station on the wall
1. Position the charging station with its rear on a wall so that the
compartment for inserting the battery is facing the right or left-
hand side.
2. Screw the charging station firmly to the wall using 3 screws
and 3 plain washers (maximum screw-in depth 6 mm).
When doing so, please note: The screws must be firmly
tightened.
Result The charging station is firmly attached to the wall.
4.5.2 Operating the charging station on a mobile
basis
1. Glue the rubber feet to the rear of the charging station.
2. Place the charging station with the rear on a level surface.
Result The charging station is used on a mobile basis (e.g. as a desktop
device).
Risk of injury from incorrectly mounted charging station!
If a charging station is mounted incorrectly, the charging station
may come off the wall or the battery may fall out.
Position and attach the charging station correctly.
To Next Page
Loading...
Need help?
General
