196 EN MEDUCORE Standard
2
WM 68401 04/2021
6 Operation
6.16 Printing ECGs and reports (only with
Printing option)
6.16.1 Connecting the printer to the device
Requirement • The printer battery is inserted (see “4.7.2 Inserting the printer
battery”, page 97).
• The printer paper is inserted (see “4.7.3 Inserting printer
paper”, page 98).
• The printer is stowed in the printer case (see “4.7.4 Stowing
the printer in the printer case”, page 100).
• A printer has been paired with the device (see “12.2 Pair
printer with device (only with Printing option)”, page 290).
Delayed therapy due to incorrect storage of the printer!
Storage outside the specified ambient conditions may lead to
printer malfunctions or damage the printer. This may delay the
patient’s therapy.
Always store the printer within the specified ambient
conditions.
In the event of problems with the printer: Carry out a function
check of the printer (see “5.6 Carrying out a function check on
the printer (only with Printing option)”, page 117).
Risk of injury from defective printer!
A defective printer may lead to electric shock if touched. This may
injure the patient or the user.
Always operate the printer in the printer case.
Delayed therapy due to printer not being ready for use!
The device cannot be connected to the printer if e-mail delivery
12-lead ECG or network data transmission are taking place in
parallel.
Wait until the e-mail delivery 12-lead ECG or network data
transmission is finished.
If necessary: Switch the printer on again.
To Next Page
Loading...
Need help?
General
