232 EN MEDUCORE Standard
2
WM 68401 04/2021
8 Hygienic reprocessing
8.1 Intervals
* In the event of visible dirt or suspected contamination.
8.2 Preparing hygienic reprocessing
Requirement • The device is switched off (see “6.2 Switching the device off”,
page 119).
• The device is disconnected from the patient.
• Battery and SD card are in the device.
• SD card cover is closed.
1. If the device is connected to line power or to a 12 V on-board
power supply: Disconnect the device from line power (see
“7.1.2 Disconnecting the device from line power”, page 219).
Alternatively:
Disconnect the device from the 12 V on-board power supply
(see “7.1.2 Disconnecting the device from line power”,
page 219).
When doing so, please note: The battery remains in the device
for hygienic reprocessing.
2. Disassemble the defibrillation electrodes/paddles and master
cable (see “7.2 Disassembling defibrillation electrodes/paddles
and master cable”, page 221).
Failure of therapy due to disinfection by immersion,
mechanical reprocessing and sterilization!
If the device, or components or accessories not designed for these
processes are subjected to disinfection by immersion, mechanical
reprocessing or sterilization, they may be damaged.
Never subject the device, or components or accessories not
designed for these processes to disinfection by immersion,
mechanical reprocessing or sterilization.
Part After every use* At least 1x weekly
All parts x x
To Next Page
Loading...
Need help?
General
