WM 68401 04/2021
MEDUCORE Standard
2
EN 93
4 Preparation
4.6.2 Removing the SD card
Requirement There is an SD card in the SD card slot.
1. Open the water jet protection of the SD card slot.
2. Briefly push in the SD card.
The SD card is ejected slightly.
3. Remove the SD card.
4. Close the water jet protection to protect the device from
ingress of dust and water.
Result The SD card is removed.
Incorrect use may result in loss of data!
If you remove the SD card while data is being written to it, data
may be lost or the SD card damaged.
Only remove the SD card with the device switched off.
To Next Page
Loading...
