CABLE ROUTING
2-60
1. License plate light lead
2. Tail/brake light assembly lead
3. Seat lock cable
4. Intake air temperature sensor
A. Route the tail/brake light assembly lead and
license plate light lead between the rib and the U-
lock holder on the rear fender, making sure that the
leads are not routed on top of the holder.
B. Fasten the tail/brake light assembly lead and
license plate light lead with the holder.
C. Route the tail/brake light assembly lead and
license plate light lead between the ribs on the rear
fender.
D. Route the intake air temperature sensor lead
under the wire harness.
E. Fasten the intake air temperature sensor lead to
the air filter case with the holder.
To Next Page
Loading...
