CHASSIS
3-23
1. Operate the brake.
2. Check:
• Front brake pad
Wear indicator grooves “1” almost disap-
peared → Replace the brake pads as a set.
Refer to “FRONT BRAKE” on page 4-25.
EAS21260
CHECKING THE REAR BRAKE PADS
The following procedure applies to all of the
brake pads.
1. Operate the brake.
2. Check:
• Rear brake pad
Wear indicators “1” almost touch the brake
disc → Replace the brake pads as a set.
Refer to “REAR BRAKE” on page 4-37.
EAS21280
CHECKING THE BRAKE HOSES
The following procedure applies to all of the
brake hoses and brake hose holders.
1. Check:
• Brake hoses
Cracks/damage/wear → Replace.
2. Check:
• Brake hose holders
Loose → Tighten the holder bolts.
3. Hold the vehicle upright and apply the brake
several times.
4. Check:
• Brake hoses
Brake fluid leakage → Replace the damaged
hose.
Refer to “FRONT BRAKE” on page 4-25,
“REAR BRAKE” on page 4-37 and “ABS (AN-
TI-LOCK BRAKE SYSTEM)” on page 4-50.
EAS21330
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
NOTE:
• The rear brake light switch is operated by
movement of the brake pedal. The rear brake
light switch is properly adjusted when the
brake light comes on just before the braking ef-
fect starts.
• If the switch is not properly adjusted, ABS mal-
function code No. 23 may be displayed.
1. Check:
• Rear brake light operation timing
Incorrect → Adjust.
2. Adjust:
• Rear brake light operation timing
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Hold the main body “1” of the rear brake light
switch so that it does not rotate and turn the
adjusting nut “2” in direction “a” or “b” until the
rear brake light comes on at the proper time.
▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS22780
BLEEDING THE HYDRAULIC BRAKE
SYSTEM (ABS)
WARNING
EWA14000
Always bleed the brake system when the
brake related parts are removed.
CAUTION:
EC3P61012
• Bleed the brake system in the following or-
der.
1
1
Direction “a”
Brake light comes on sooner.
Direction “b”
Brake light comes on later.
To Next Page
Loading...
