ENGINE SPECIFICATIONS
2-2
EAS20290
ENGINE SPECIFICATIONS
Engine
Engine type Liquid cooled 4-stroke, DOHC
Displacement 1298.0 cm³ (79.20 cu.in)
Cylinder arrangement Forward-inclined parallel 4-cylinder
Bore × stroke 79.0 × 66.2 mm (3.11 × 2.61 in)
Compression ratio 10.80 :1
Standard compression pressure (at sea level) 1600 kPa/400 r/min (228 psi/400 r/min) (16.0
kgf/cm²/400 r/min)
Minimum–maximum 1390–1790 kPa (198–255 psi) (13.9–17.9
kgf/cm²)
Starting system Electric starter
Fuel
Recommended fuel Regular unleaded gasoline only (Europe) (ZA)
Unleaded gasoline only (AUS)
Fuel tank capacity 25.0 L (6.61 US gal) (5.50 Imp.gal)
Fuel reserve amount 5.5 L (1.45 US gal) (1.21 Imp.gal)
Engine oil
Lubrication system Wet sump
Type SAE20W40
Recommended engine oil grade API service SE, SF, SG type or higher
Engine oil quantity
Total amount 4.90 L (5.18 US qt) (4.31 Imp.qt)
Without oil filter cartridge replacement 3.80 L (4.02 US qt) (3.34 Imp.qt)
With oil filter cartridge replacement 4.00 L (4.23 US qt) (3.52 Imp.qt)
Oil pressure (hot) 30.0 kPa/1000 r/min (4.4 psi/1000 r/min) (0.30
kgf/cm²/1000 r/min)
Final gear oil
Type Shaft drive gear oil (Part No.: 9079E-SH001-00)
Quantity 0.20 L (0.21 US qt) (0.18 Imp.qt)
Oil pump
Oil pump type Trochoid
Inner-rotor-to-outer-rotor-tip clearance Less than 0.12 mm (0.0047 in)
Limit 0.20 mm (0.0079 in)
Outer-rotor-to-oil-pump-housing clearance 0.09–0.15 mm (0.0035–0.0059 in)
Limit 0.22 mm (0.0087 in)
Oil-pump-housing-to-inner-and-outer-rotor
clearance 0.03–0.08 mm (0.0012–0.0032 in)
Limit 0.15 mm (0.0059 in)
Bypass valve opening pressure 78.4–117.6 kPa (11.4–17.1 psi) (0.78–1.18
kgf/cm²)
Relief valve operating pressure 480.0–560.0 kPa (69.6–81.2 psi) (4.80–5.60
kgf/cm²)
Cooling system
Radiator capacity (including all routes) 2.60 L (2.75 US qt) (2.29 Imp.qt)
Radiator capacity 0.65 L (0.69 US qt) (0.57 Imp.qt)
To Next Page
Loading...
