CABLE ROUTING
2-64
1. Hydraulic unit
2. Proportioning valve
3. Brake hose (proportioning valve to rear brake
caliper)
4. Brake hose (rear brake master cylinder to
hydraulic unit)
5. Brake hose (hydraulic unit to metering valve)
6. Brake hose (hydraulic unit to front brake calipers)
7. Brake hose (front brake master cylinder to
hydraulic unit)
8. Brake hose (hydraulic unit to proportioning valve)
9. Brake hose (metering valve to right front brake
caliper)
10. Metering valve
11. ABS motor relay
12. Hydraulic unit solenoid coupler
13. Hydraulic unit breather hose
14. Stator coil lead
15. Rectifier/regulator lead
16. Rectifier/regulator
17. ABS motor coupler
A. Install the ABS motor relay completely onto the tab
on the hydraulic unit bracket.
B. Install the hydraulic unit solenoid coupler
completely onto the tab on the hydraulic unit
bracket.
C. 87
–93°
D. 5–7 mm (0.20–0.28 in)
E. Install the hydraulic unit breather hose so that the
white paint mark on the hose is facing down.
F. Make sure that the brake hose (hydraulic unit to
proportioning valve) contacts the end of the brake
hose (hydraulic unit to metering valve).
G. Make sure that the brake hoses contact the
stoppers on the hydraulic unit.
H. Pass the hydraulic unit breather hose, stator coil
lead, and rectifier/regulator lead though the guide.
I. 36–42°
J. Install the ABS motor coupler completely onto the
tab on the hydraulic unit bracket.
To Next Page
Loading...
