FEATURES
1-29
NOTE:
If the multi-function display indicates fault code
52, this could be caused by transponder interfer-
ence. If this fault code appears, try the following.
1. Use the code re-registering key to start the
engine.
NOTE:
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off, and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, re-register the standard keys.
If the multi-function display indicates any fault
codes, note the code number, and then check
the vehicle.
Refer to “IMMOBILIZER SYSTEM” on page
8-99.
To Next Page
Loading...
