FUEL INJECTION SYSTEM
8-78
Fault code No. 46 Symptom Power supply to the fuel injection system is not normal.
Diagnostic code No. — —
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Connections
• Wire harness ECU coupler
• Check the coupler for any pins
that may be pulled out.
• Check the locking condition of
the coupler.
• If there is a malfunction, repair it
and connect the coupler se-
curely.
Starting the en-
gine and oper-
ating it at idle.
2 Faulty battery. • Replace or charge the battery.
Refer to “CHECKING AND
CHARGING THE BATTERY” on
page 8-154.
3 Malfunction in rectifier/regulator • Replace if defective.
Refer to “CHARGING SYS-
TEM” on page 8-17.
4 Open or short circuit in wire harness. • Repair or replace if there is an
open or short circuit.
• Between battery and main
switch coupler.
(red–red)
• Between main switch coupler
and ignition fuse.
(brown/blue–brown/blue)
• Between ignition fuse and ECU
coupler.
(red/white–red/white)
Fault code No. 50 Symptom Faulty ECU memory. (When this malfunction is detected in
the ECU, the fault code number might not appear on the
meter.)
Diagnostic code No. — —
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Malfunction in ECU. Replace the ECU.
NOTE:
Do not perform this procedure
with the main switch turned to
“ON”.
Turning the
main switch to
“ON”.
To Next Page
Loading...
