CABLE ROUTING
2-50
1. Rear wheel sensor lead
2. Rear brake fluid reservoir
3. Rear brake light switch lead
4. Hydraulic unit
5. Brake hose (front brake master cylinder to
hydraulic unit)
6. Brake hose (hydraulic unit to proportioning valve)
7. Brake hose (hydraulic unit to metering valve)
8. Brake hose (hydraulic unit to front brake calipers)
9. Brake hose (rear brake master cylinder to
hydraulic unit)
10. Brake pipe (metering valve to right front brake
caliper)
11. Rear brake light switch
12. Brake hose (proportioning valve to rear brake
caliper)
A. Route the rear wheel sensor lead to the inside of
the swingarm, making sure that the lead does not
protrude above the swingarm.
B. 45
–55 mm (1.77–2.17 in)
C. 10–20 mm (0.39–0.79 in)
D. Route the rear brake light switch lead under the
rear wheel sensor lead.
E. Fasten the rear wheel sensor lead to the brake
hose (proportioning valve to rear brake caliper)
with the two holders, making sure that the fastener
of each holder faces inward.
To Next Page
Loading...
