• Start the engine and accelerate
to
about
5,000 r/min.
iIj
Charging voltage:
14
V
at
5,000 r
Imin
NOTE:
Use a
fully
charged battery.
I OUTOF
•
SPECIFICATION
EB80<W12
4.Stator coil resistance
• Disconnect the
AC
magneto
coupler
from
the wire harness.
• Connect the pocket tester
(Q
x
1)
to
the
stator coils.
Tester (+) lead
---7
White
terminal
Q)
Tester (-) lead
---7
White
terminal
®
Tester (+) lead
---7
White
terminal
Q)
Tester (-) lead
---7
White
terminal
@
• Measure the stator coil resistance.
ijj
Stator
coil resistance:
0.50
'Y
0.62 Q
at
20"C
(68"F)
n
BOTH
MEET
V
SPECIFICATION
EB80401S
5.Wiring connections
• Check the connections
of
the entire
charging system.
Refer
to
I'CIRCUIT DIAGRAM".
~
CORRECT
IReplace the rectifier/regulator.
CHARGING SYSTEM IELECI
L:=:J
I
MEETS
SPECIFICATION
:i}
IThe charging circuit is not faulty.
OUT
OF
SPECIFICATION
l
IReplace the statorcoil assembly.
POOR
CONNECTION
~
IProperly connect the charging system.
7 - 23
To Next Page
