Yamaha XVS650 - Handlebar Inspection; Handlebar Installation

____________ H_A_ND_L_E_BA_R_ICHASIAI
HANDLEBAR INSPECTION
1.1nspect:
• Handlebar
Bends/cracks/damage
~ Replace.
. ~ ----------
Do not attempt to straighten a bent han-
dlebar as
this may dangerously weaken it.
********************~*************
Left handlebar grip replacement steps:
eRemove the handlebar grip.
e Apply a
light coat of rubber adhesive on
the end
of the handlebar.
elnstall the handlebar grip.
NOTE: _
Wipe off excess adhesive with a clean rag.
A WARNING
Do not touch the grip until the adhesive
has set.
**********************************
HANDLEBAR INSTALLATION
1.lnstall:
• Washers
• Handlebar holder (lower)
CD
• Cable guide ®
NOTE: _
Temporarily tighten the nuts @.
2.lnstall:
• Handlebar
• Handlebar holder {upper)
~~23~N~m~(2~.3-m----. k-g-, 1~6~.6~ft-.~lb"":""") I
NOTE: _
• The upper handlebar holder should be
installed with the punch mark ® forward
~.
6 - 42