YASKAWA VS-656MR5

6-1
6
Trial Operation
This chapter explains the setup for trial operation, and gives examples of
Digital Operator operations and trial operation.
6.1 Procedure 6 -4............................
6.2 Trial Operation Procedure 6 -5..............
6.2.1 Checking the Power Supply Voltage 6 -5............
6.2.2 Setting the YENET1200 Node Address 6 -5.........
6.2.3 Turning ON the Control Power Supply 6 -5..........
6.2.4 Turning ON the Main Circuit Power Supply 6 -5......
6.2.5 Checking the Motor Cooling Fan 6 -6...............
6.2.6 Starting Trial Operation 6 -6.......................
6.3 Converter and Inverter LED Displays 6 -7.....
6.3.1 Display Details Tables 6 -7........................
6.3.2 Display when the Converter Control Power Supply Is
Turned ON 6 -7................................
6.3.3 Display when an Error Occurs 6 -8.................
6.4 Constant Settings 6 -9......................
6.4.1 User Constant Functions Table 6 -9................
6.4.2 Soft Start Time Setting (TSFS: C1-10) 6 -10..........
6.4.3 Load Factor Meter Full Scale (LMFS: C1-18) 6 -10....
6.4.4 Zero Speed Detection Level (ZSLVL: C1-19) 6 -10....
6.4.5 Speed Agree Width (AGRBD: C1-20) 6 -10...........
6.4.6 Speed Detection Level and Detection Width
(SDLVL: C1-21, SDHYS: C1-22) 6 -11.............
6.4.7 Torque Detection Signal Operation Level
(TDLVL: C1-23) 6 -11...........................
6.4.8 External Control Torque Limit Level
(TLEXT: C1-24) 6 -11............................
6.4.9 Motor Code Selection (MTR: C1-25) 6 -11...........
6.4.10 Rated Speed (S100: C1-26) 6 -13..................
6.4.11 Gear Ratios (RHGR: C1-27, RMGR: C1-28,
RLGR: C1-29) 6 -13.............................
6.4.12 Servo Mode Flux and Base Speed Ratio
(ΦSVH: C1-31, RBSH: C1-32,
ΦSVL: C1-33, RSBL: C1-34) 6 -13................
6