Chapter 3 PERFORMING MEASUREMENTS
3-9
3.5 Setting the Measurement Conditions/Auto Search
Conditions [Step 4]
Before starting measurement of the optical fiber, it is necessary to set conditions under
which the measurement is to be performed. This section explains how to change the
following measurement conditions and auto search conditions.
• Wavelength
• Measurement condition auto set
• Distance range
• Pulse width
• Attenuation
• Average condition
• Average time / average interval
• Group index
• Data size
• Average method
• Auto saving
• Event search
• Approximate method
• Back scatter level
• Splice loss threshold
• Return loss threshold
• Fiber end threshold
• Filter
• Plug check
• Average measurement continue
To Next Page
Loading...
