Chapter 3 PERFORMING MEASUREMENTS
3-71
When “MANUAL” is Selected for “EVENT SEARCH”
The following window will appear at the end of average measurement if “MANUAL” is
currently selected for “EVENT SEARCH”.
If [F3] is pressed in this window, auto search will be performed automatically and
the window shown on page 3-68 will appear.
For the method of searching events, refer to page 3-35.
This section explains how to check the following items manually.
• Distance from the origin
• Distance between two points
• Splice loss
• Return loss
TIP
Refer
To Next Page
Loading...
