Chapter 4 ENTERING CHARACTERS
4-8
Changing a Character
This section explains how to change a character by taking an example in which a wrong
character is entered by mistake into the label.
1.
Display the label input window.
For the method of displaying the label input window, refer to page 4-3.
2. Push the rotary knob to switch the input mode to “OVERWRITE”.
3. Locate the blink cursor to the character “5” to be changed by turning the rotary
knob.
4. Locate the cursor to “6” by using the arrow key.
5. Press [ENTER].
6. Press [F5] (DONE) to register the label.
Wrong character
"AQ7250 OTDR"
Current label
"AQ7260 OTDR"
Label to be entered
Refer
To Next Page
Loading...
Need help?
General
